cancel
Showing results for 
Search instead for 
Did you mean: 

Gun Safe

Frequent Contributor

Gun Safe

I'm trying to work out how to Iris-enable my gun safe. The safe has a small hole in back you can run power in and out of.
Obviously i can do a motion sensor externally, or a camera, or even a proximity open/close switch (useless tho). 
Has any figured a way to make the antenna of a sensor external? 

I'm pretty sure the steel and construction of the safe will block the ZWave signal. Unless, I put a range extender right beside the safe maybe

 

3 REPLIES
Community Manager

Re: Gun Safe

Contact sensor on the safe door exterior?

An interior sensor would be much more difficult although depending on the space available you could put a camera inside (run the ethernet cable and power through the hole in the back).

 

-Mike

Highlighted
Tinkerer

Re: Gun Safe

I tried installing one inside a gun safe and it always disconnected a short time after closing the door.  I tried installing a smart plug near the safe with same result.  I ended up installing it on the outside.

 

Yes, it can be defeated when mounted externally.  You can remove the cover of the battery part of the sensor and run a screw into the safe to help make it more secure.